Hitachi VM-E230A Bedienungsanleitung PDF herunterladen (Seite 52)

Advanced Techniques

PHILIPS

RCA DISPLAY

Zenith COUNTER RESET

Magnavox TITLE ON/OFF

Note: The remote control code is held in memory until it is changed or the batteries are

replaced.

Note: Point the remote control straight at the VCR's infrared receiver for operation.

Note: Use the remote control indoors. When the infrared receivers of the VCR and

camcorder are exposed to direct sunlight or strong artificial light, the remote control may

not operate correctly.

Note: The remote control cannot be operated if there is an obstacle between the remote

control and infrared receiver. Especially, be careful of this during dubbing.

Note: When the edit remote control is connected to the camcorder, the buttons marked * in

the figure above perform the same operations as those of the other remote control

provided.

Operation

You can select up to four different scenes or segments to be copied at one time.

Note: If sunlight or strong artificial light strikes the camcorder's infrared receiver, the editing

operation may not be possible.

Programmable Edit Hookup

1. Use the audio/video output cable to connect the camcorder and VCR as illustrated

and then connect the edit remote control to the camcorder.

Note: If your VCR has two (stereo) AUDIO IN jacks, connect the audio plug to the left-

channel AUDIO IN jack.

2. Insert a recorded tape into the camcorder.

3. Set the CAM/OFF/VIDEO switch of the camcorder to VIDEO. Turn the recording VCR

on and select line input.

4. Press the PROGRAM button of the remote control. The program display appears in

the viewfinder.

Note: If your VCR is connected to a TV, the program display will also appear on the TV

screen.

5. Press the button and use the or button to search for the starting point of the

segment you want to copy. Press

and then to set the camcorder to the play pause

mode.

The linear time counter counts when searching for the starting point.

Use the FORWARD and REVERSE buttons in the play or pause mode to fine adjust the

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

Keine Kommentare

Hitachi VM-E230A Bedienungsanleitung Seite 52