Hitachi VM-E625LA Bedienungsanleitung PDF herunterladen (Seite 41)

Advanced Techniques - 41 -

back through the tape without affecting the tape in the VCR.

Use the F.FWD and REW buttons to search the tape. Press the PLAY button to resume normal playback. To

resume recording on the tape in the VCR, press the Start/Stop button and then the S.EDIT button.

To fast forward or rewind the tape, press the STOP button, then F.FWD or REW. To return to recording on the

tape in the VCR, press the STOP button, then the PLAY button, then the Start/Stop button, and then the S.EDIT

button.

8. To stop recording at a certain point turn on the camcorder's linear time counter with memory ("Using Memory,"

p.41). Press the COUNTER RESET button on the remote control where you wish the recording to stop. The linear

time counter resets to 0:00:00M. Rewind to the point where you wish to start recording and start copying. When

the linear time counter reaches 0:00:00 the recording stops automatically, pausing the VCR in the record mode.

Note: If the tape counter reads "0:00:00M" you cannot start recording.

Note: Reduce the volume of the camcorder as low as possible during dubbing. Otherwise the played back

pictures could be distorted.

Simple Programmable Edit (Edit remote control is optional accessory)

Simple programmable edit allows you to program your camcorder to select the scenes you want to copy from a

pre-recorded tape. Use the edit remote control (optional) to easily copy scenes from a recorded tape in the

camcorder (playback machine) onto a blank tape in a table-top VCR which handles infrared signals (recording

machine).

Note: Only the VM-RM20EDA edit remote control (optional) can be used with this camcorder.

Note: Some VCRs cannot be operated by the edit remote control (optional).

Example of Programmable Editing

Programming the Remote Control for the VCR

It is necessary to program the edit remote control to match the VCR before starting editing.

1. Turn the VCR on.

2. Aim the remote control at the infrared receiver on the VCR and press the VCR SET button on the remote

control and hold it, then press the button corresponding to the VCR's maker code. For example, if you have a

RCA VCR, press the VCR SET button and hold it, then press the DISPLAY button. To check whether the remote

control code matches that of your VCR or not, point the remote control at the infrared receiver on the VCR and

press the VCR SET button and hold it. If the remote control code has been set, the VCR channel is counted up

automatically.

Note: Your VCR should have an infrared remote control.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 53 54

Keine Kommentare

Hitachi VM-E625LA Bedienungsanleitung Seite 41