Hitachi COMPAQ 8000 Bedienungsanleitung Seite 1

Hardware Reference GuideHP Compaq 8000 Elite Ultra-Slim Desktop Business PC

KeyboardFigure 1-4 Keyboard ComponentsTable 1-3 Keyboard Components1 Function Keys Perform special functions depending on the software application b

Windows Logo Key Displays or hides the Start menuWindows Logo Key + d Displays the DesktopWindows Logo Key + m Minimizes all open applicationsShift +

Windows Logo Key + + (on numpad) Zooms inWindows Logo Key + - (on numpad) Zooms outSerial Number LocationEach computer has a unique serial number and

2 Hardware UpgradesServiceability FeaturesThe computer includes features that make it easy to upgrade and service. No tools are needed for mostof the

Connecting the Power CordWhen connecting the power supply, it is important to follow the steps below to ensure the power corddoes not pull free from t

Removing the Computer Access PanelTo access internal components, you must remove the access panel:1. Remove/disengage any security devices that prohib

Replacing the Computer Access Panel1. Align the tabs on the panel with the slots on the chassis then slide the panel towards the front ofthe chassis u

Removing and Replacing the Front Bezel1. Remove/disengage any security devices that prohibit opening the computer.2. Remove all removable media, such

To replace the front bezel:1. Insert the three hooks on the bottom side of the bezel into the rectangular holes on the chassis (1)then rotate the top

Removing a Bezel BlankOn some models, there is a bezel blank covering the external drive bay that needs to be removed beforeinstalling a drive. To rem

© Copyright 2009 Hewlett-PackardDevelopment Company, L.P. Theinformation contained herein is subject tochange without notice.Microsoft, Windows, and W

Changing from Desktop to Tower Configuration1. Remove/disengage any security devices that prohibit opening the computer.2. Remove all removable media,

Installing Additional MemoryThe computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-SDRAM) small outline dual inline

Populating SODIMM SocketsThere are two SODIMM sockets on the system board, with one socket per channel. The sockets arelabeled XMM1 and XMM3. The XMM1

Installing SODIMMsCAUTION: You must disconnect the power cord and wait approximately 30 seconds for the power todrain before adding or removing memory

8. If you are adding a second SODIMM, remove the SODIMM from the top XMM1 socket to accessthe bottom XMM3 socket. Press outward on the two latches on

12. If the computer was on a stand, replace the stand.13. Reconnect the power cord and turn on the computer.14. Lock any security devices that were di

Preparing the New Optical DriveBefore the new optical drive can be used, the release latch must be attached.1. Peel the backing off the adhesive on th

3. Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),then connect the cable to the rear of the dr

Replacing the Hard DriveNOTE: The Ultra-Slim Desktop supports only 2.5-inch Serial ATA (SATA) internal hard drives; parallelATA (PATA) internal hard d

9. Lift the hard drive carrier straight up and out of the chassis.Figure 2-15 Removing the Hard Drive Carrier10. Remove the four guide screws from th

About This BookThis guide provides basic information for upgrading this computer model.WARNING! Text set off in this manner indicates that failure to

12. Position the hard drive so that the top of the hard drive is up against the top of the carrier (1) sothat the circuit board on the bottom of the h

14. To place the hard drive carrier back in the chassis, align the guide screws with the slots on thedrive bay, drop the carrier straight down into th

Installing and Removing a Port CoverAn optional rear port cover is available for the computer.To install the port cover:1. Thread the cables through t

A SpecificationsTable A-1 SpecificationsDesktop Dimensions (in the desktop position)HeightWidthDepth(depth will increase if the computer is equipped

Rated Input Current (maximum)12.4A @ 100VAC 1.2A @ 200VAC1This system utilizes an active power factor corrected external power supply. This allows the

B Battery ReplacementThe battery that comes with the computer provides power to the real-time clock. When replacing thebattery, use a battery equivale

NOTE: On some computer models, it may be necessary to remove an internal component to gainaccess to the battery.8. Depending on the type of battery ho

b. Insert the new battery and position the clip back into place.Figure B-3 Removing a Coin Cell Battery (Type 3)NOTE: After the battery has been repl

C Security Lock ProvisionsNOTE: For information on data security features, refer to the Desktop Management Guide and theHP ProtectTools Security Manag

Figure C-2 Installing a Cable with a Port Cover InstalledPadlockFigure C-3 Installing a PadlockENWW Installing a Security Lock 33

iv About This Book ENWW

HP Business PC Security Lock1. Fasten the security cable by looping it around a stationary object.Figure C-4 Securing the Cable to a Fixed Object2. T

3. Screw the lock to the chassis using the screw provided.Figure C-6 Attaching the Lock to the Chassis4. Insert the plug end of the security cable in

4. Disconnect the power cord from the power outlet and disconnect any external devices.CAUTION: Regardless of the power-on state, voltage is always pr

9. Install the security screw through the middle front bezel release tab and into the chassis to securethe front bezel in place.Figure C-9 Installing

D Electrostatic DischargeA discharge of static electricity from a finger or other conductor may damage system boards or otherstatic-sensitive devices.

E Computer Operating Guidelines,Routine Care and Shipping PreparationComputer Operating Guidelines and Routine CareFollow these guidelines to properly

Optical Drive PrecautionsBe sure to observe the following guidelines while operating or cleaning the optical drive.Operation●Do not move the drive dur

IndexAaccess panellocking and unlocking 32removing 9replacing 10application key 4audio connectors 2Bbattery replacement 29bezel, removing 11Ccable loc

power supplyoperating voltage range 27product ID location 6Rrear panel components 3release latchattaching optical drive 20removingaccess panel 9batter

Table of contents1 Product FeaturesStandard Configuration Features ...

Appendix C Security Lock ProvisionsInstalling a Security Lock ...

1 Product FeaturesStandard Configuration FeaturesThe HP Compaq Ultra-Slim Desktop computer comes with features that may vary depending on themodel. Fo

Front Panel ComponentsDrive configuration may vary by model.Figure 1-2 Front Panel ComponentsTable 1-1 Front Panel Components1 Optical Drive 5 Micro

Rear Panel ComponentsFigure 1-3 Rear Panel ComponentsTable 1-2 Rear Panel Components1 Line-Out Connector for powered audiodevices (green)6 Power C