Hitachi L300P Bedienungsanleitung PDF herunterladen (Seite 239)

L300P Inverter

Appendix B

B–13

Command – 07 The 07 command sets a parameter value equal to the value specified in the transmission.The

frame format of command 07 follows the diagram and specification table.

Note that the parameter F001, the output frequency, can be set more directly with host

command 01 instead of with this command. Use the codes in the following table for setting

parameters associated with H003 and H203.

Element Description Size Value

STX Control code (STart of TeXt) 1 byte STX (0x02)

Node Node (station) address of inverter 2 bytes 01 to 32, and FF (broadcast to all

nodes)

Command Transmission command 2 bytes 07

Parameter Function code of parameter 4 bytes F002..., A001..., B001..., C001...,

H003..., P001...

Data Transmission data 8 bytes Value of parameter times ten as

ASCII char. code, except for

H003 and H203 (see table below)

BCC Block check sum code 2 bytes Exclusive OR of Node,

Command, and Data

[CR] Control code (carriage return) 1 byte [CR] (0x0D)

Code Data 00 01 02 03 04 05 06 07 08 09 10

U.S. mode (B85=00, 02) 0.2 kW 0.4 0.75 1.5 2.,2 3.7

EU mode (B85=01) 0.2 kW 0.37 0.55 0.75 1.1 1.5 2.2 3.0 4.0

Code Data 11 12 13 14 15 16 17 18 19 20 21

U.S. mode (B85=00, 02) 5.5 kW 7.5 11 15 18.5 22 30 37 45 55 75

EU mode (B85=01) 5.5 kW 7.5 11 15 18.5 22 30 37 45 55 75

STX Node Command Data BCC [CR]

Frame format

Parameter

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 263 264

Keine Kommentare

Hitachi L300P Bedienungsanleitung Seite 239